SHETIME WAFP5-T1T1-2020-D
Product Overview
This document outlines the test modes and requirements for a connector product, covering durability, electrical characteristics, mechanical performance, and environmental endurance. It details specific tests such as contact resistance, vibration, thermal aging, insulation resistance, and temperature cycling to ensure product reliability and performance under various operating conditions.
| Item | Test Mode | Requirement | Details |
|---|---|---|---|
| Durability | Mate connectors up to 30 cycles at a maximum rate of 10 cycles per minute prior to environmental test | Not Specified | Not Specified |
| Contact Resistance | Hfpt A | <30m | |
| Vibration | Connector combination state of the welding circuit board as test samples, resistance to vibration test, whether to produce discontinuous current (off) | Contact resistance: <30m; Current Discontinuity: 1 micro second Max | Frequency: 10-55-10 Hz/minute; Amplitude: 1.5mm p-p; Direction: Axis of up and down, right the left, front and back; Period: 2 hours for each direction |
| Thermal Aging | Connector combination condition is placed in the oven, high temperature aging test | Appearance: No damage; Contact Resistance: <30m | Temperature: 852C; Period: 96 hours continuously |
| Insulation Resistance | Apply 500V DC (rms) for 1 minute between adjacent contacts | >100 M | |
| Terminal crimping wire strength (AWG#28 wire) | Axial pullout force | >13N | Rate: 25 3mm per minute |
| Terminal crimping wire strength (AWG#30 wire) | Axial pullout force | >8N | Rate: 25 3mm per minute |
| Terminal crimping wire strength (AWG#32 wire) | Axial pullout force | >6N | Rate: 25 3mm per minute |
| Fixed terminals and hole seat | Pull out force | >8N per contact | Rate: 25 3mm per minute along the wire direction |
| Single contact insertion force | Housing together with terminal ends with wafer matched | <2N | Rate: 25 3mm per minute |
| Single contact withdrawal force | Housing together with terminal ends with wafer matched | >0.2N | Rate: 25 3mm per minute |
| Pin Retention force | Force on the pin end | >3N per contact | Rate: 25 3mm per minute |
| Temperature Rise | Mate connector measure temperature rise at maximum rated current | 5L (unit unspecified) | |
| Humidity | Constant temperature and humidity test | Appearance: No damage; Contact Resistance: <30m; Insulation Resistance: 50M; Withstand Voltage: No breakdown or flashover | Temperature: 40 2C; Relative humidity: 90-95%RH; Period: 96 hours continuously |
| Temperature Cycling | Thermal shock test | Same as paragraph 8.3 (Contact Resistance, Insulation Resistance, Withstand Voltage) | One cycle: -55+3C (30min), Room temp. (10-15 min), 85+3C (30min), Room temp. (10-15 min). Total cycle: 5 cycles. |