SHETIME WAFP6-T1T1-2020-D
Product Overview
This product appears to be a connector with various performance and reliability tests detailed, including Durability, Contact Resistance, Vibration, Thermal Aging, Insulation Resistance, Mechanical Performance (Terminal crimping, Insertion/Withdrawal forces, Pin Retention), Temperature Rise, Humidity, and Temperature Cycling. These tests are crucial for ensuring the connector's performance in demanding environments.
Technical Specifications
| Item | Test Mode | Requirement | Details |
|---|---|---|---|
| Durability | Mate connectors up to 30 cycles | Maximum rate of 10 cycles per minute prior to environmental test | |
| Contact Resistance | Pre-test | <30m | |
| Vibration | Connector combination state of the welding circuit board as test samples | Resistance to vibration test, whether to produce discontinuous current (off) | Frequency: 10-55-10 Hz/minute (35%) Amplitude: 1.5mm p-p (#& &) Direction: Axis of up and down, right to left, front and back (5%) Period: 2 hours for each direction |
| Vibration (Post-test) | Measuring | Contact resistance: <30m Current Discontinuity: 1 micro second Max | Appearance: No damage |
| Thermal Aging | Connector combination condition is placed in the oven | High temperature aging test, after the test and measurement of contact resistance | Temperature: 85 2C Period: 96 hours continuously |
| Thermal Aging (Post-test) | Measuring | Appearance: No damage Contact Resistance: <30m | |
| Insulation Resistance | Apply 500V DC (rms) for 1 minute between adjacent contacts | More than 100 M | |
| Terminal crimping wire strength (AWG#28) | Axial pullout force | More than 13N | Rate of 25 3mm per minute |
| Terminal crimping wire strength (AWG#30) | Axial pullout force | More than 8N | Rate of 25 3mm per minute |
| Terminal crimping wire strength (AWG#32) | Axial pullout force | More than 6N | Rate of 25 3mm per minute |
| Fixed terminals and hole seat | Pull out force | More than 8N (Per contact) | Rate of 25 3mm along the wire direction |
| Single contact insertion force | Wafer matched insertion force test | Less than 2N | Rate of 25 3mm per minute |
| Single contact withdrawal force | Wafer matched pull-out test | More than 0.2N | Rate of 25 3mm per minute |
| Pin Retention force | Pin end pull-out force test | More than 3N (Per contact) | Rate of 25 3mm per minute |
| Temperature Rise | Mate connector measure temperature rise | 5L (Max rated current) | |
| Humidity | Constant temperature and humidity test | Insulation Resistance: 50M Contact Resistance: <30m Withstand Voltage: No breakdown or flashover | Temperature: 40 2C Relative humidity: 90-95%RH Period: 96 hours continuously |
| Temperature Cycling | Thermal shock test | Same as paragraph 8.3 (Contact Resistance, Insulation Resistance, Resistance to Voltage) | One cycle: -55+3C (30min) -> Room temp. (10-15 min) -> 85+3C (30min) -> Room temp. (10-15 min) Total cycle: 5 cycles |