SHETIME WAF05-T1T1-2021-D
Product Overview
This product undergoes rigorous testing to ensure its performance and durability under various environmental and mechanical conditions. Key tests include Durability, Contact Resistance, Vibration, Thermal Aging, Insulation Resistance, Mechanical Performance (Terminal crimping wire strength, Fixed terminals and hole seat, Single contact insertion/withdrawal force, Pin Retention force), Temperature Rise, Humidity, and Temperature Cycling.
| Item | Test Mode | Requirement | Details |
|---|---|---|---|
| Durability | Mate connectors up to 30 cycles at a maximum rate of 10 cycles per minute prior to environmental test | AERET SRS EAREW R, SN BHT 10 KiRA SR, ELE 30 KIRA SR LE R | Contact Resistance: <30m |
| Vibration | Connector combination state of the welding circuit board as test samples, resistance to vibration test. Frequency(35%):10-55-10 Hz/minute, Amplitude( #& & ):1.5mm p-p, Direction(J7 [A]): Axis of up and down, right the left, front and back. Period: 2 hours for each direction. | Appearance: No damage, Contact Resistance: <30m, Current Discontinuity: 1 micro second Max | PR3} |
| Thermal Aging | Connector combination condition is placed in the oven at 85+ 2 C for 96 hours continuously. | Appearance: No damage, Contact Resistance: <30m | i 1 iR |
| Insulation Resistance | Apply 500V DC(rms) for 1 minute between adjacent contacts. | More than 100 M | 2z FfH |
| Terminal crimping wire strength | AWG#28 wire: pullout force. AWG#30 wire: pullout force. AWG#32 wire: pullout force. | More than 13N (AWG#28), More than 8N (AWG#30), More than 6N (AWG#32) | S B SR |
| Fixed terminals and hole seat | The terminal and the hole seat are pulled out from the hole in the seat capacity at a rate of 25 + 3mm per minute along the wire direction. | More than 8N per contact | ST 5 FLIEIE 5 |
| Single contact insertion force | The Housing together with the terminal ends with Wafer matched, inserting force test at a rate of 25 3mm per minute. | Less than 2N | RN S |
| Single contact withdrawal force | The Housing together with the terminal ends with Wafer matched, pull-out test at a rate of 25 + 3mm per minute. | More than 0.2N | AR ) |
| Pin Retention force | Exerts a force on the pin end at a rate of 25 + 3mm per minute until the needle exits the seat. | More than 3N per contact | PIN [l 52 |
| Temperature Rise | Mate connector measures the temperature rise of contact when the maximum rated current is passed. | 5L | HERETRERESR, BlR AT R B EFHE |
| Humidity | Connector combination under constant temperature (40 2 C) and humidity (90-95%RH) for 96 hours continuously. | Appearance: No damage, Contact Resistance: <30m, Insulation Resistance: 50M, Withstand Voltage: No breakdown or flashover | {5 #IE |
| Temperature Cycling | One cycle consists of: -55+3C (30min), Room temp. (10-15 min); 85 +3C (30min), Room temp. (10-15 min). Total cycle: 5 cycles. | Same as paragraph 8.3 | R PETRE |